Overview

The NOCO GENPRO10x2 is a 20 Amp 2-bank waterproof on-board marine battery charger and battery maintainer. The GENPRO10X2 has two 12 volts outputs meant for individual 12v batteries or battery banks. The charger can be used to charge two 12v banks or one 24v battery bank using 12v batteries.

The lithium boat battery charger is fully sealed with an IP68 rating which makes it a 100% waterproof. Even with the charger being completely sealed it features a new integrated thermal sensor offering thermal compensation down to -4°F and up to 104°F. With the chargers Advanced Diagnostics, it makes it completely automatic for year-round charging and no need to worry about undercharging or overcharging batteries.

Typical installation is to maintain a 12v trolling motor battery and a 12v starting battery. Another popular installation is to maintain a 24-volt series system using two 12v batteries for a trolling motor.

The NOCO GENPRO series chargers offer several charging modes to meet your needs! Each bank is individually controlled allowing you to select the appropriate battery type for each individual bank. The charger features the following charging modes:

• 12v Mode: Meant for charging Wet Cell, Enhanced Flooded, Maintenance-Free and Calcium Batteries.
• 12v AGM Mode: Meant for 12v AGM Batteries.
• 12v Lithium mode: Meant for 12v Lithium-Ion batteries including LifePo4 batteries. For use on batteries that have a Battery Management System (often referred to as a BMS).
• 12v Repair Mode: An advanced battery recovery mode to repair old, idle, or stratified batteries.
• Force Mode: This mode will attempt to recover a battery lower than 1v. Charger will force output for five minutes to raise the battery voltage so that it can charge the battery normally.

Features

• For Flooded, Gel, AGM, & Lithium
• Sealed with IP68 waterproof rating
• Low 1-Volt Charge Detection!
• Force Mode for batteries below 1-volt
• Reverse Polarity Protection
• 3-Year Warranty

Technical Specifications